Turning the high beams on/off manually
■ Changing to the high beams
● Push the lever forward.
The Automatic High Beam indicator will turn off
and the high beam indicator will turn on.
Pull the lever to its original position to enable the
Automatic High Beam system again.
■ Changing to the low beams
● Press the Automatic High Beam switch.
The Automatic High Beam indicator will turn off.
Press the switch to enable the Automatic High
Beam system again.
Temporarily changing to the low beams
It is recommended to switch to the low beams when use of the high beams is
inappropriate or when the high beams may cause problems or distress to other
drivers or pedestrians nearby.
● Pull the lever rearward and then return it to its
original position.
The high beams will illuminate while the lever
is pulled, however, after the lever is returned to
its original position, the low beams will remain
on for a certain amount of time. After this, the
Automatic High Beam system will operate.
3-1. Driving when the surrounding area is dark
243
3
Driving according to the conditions
To Next Page
Loading...
