Lane Change Assist
*
LCA (Lane Change Assist)
LCA functions
This function is linked to the LTA and provides assistance in performing lane
changes through steering wheel operations when the turn signal lever is held
partway
When not using the LCA system, turn it off using the LCA switch.
Use the this function only on highways and expressways.
The steering assist operation can be overridden by the steering wheel operation of the
driver.
The lane change assist function is not designed to operate when changing lanes at a
junction.
WARNING
■ Before using the LCA system
● Do not overly rely on the LCA system.
The LCA system is a system which provides automated assistance in driving. However,
as it is not a system which reduces the need for checking an adjacent lane for
other vehicles, approaching vehicles, etc. when changing lanes. The driver is solely
responsible for paying attention to their surroundings and operating the steering
wheel as necessary to ensure safety.
Also, do not use the LCA to change lanes into which a lane change should not be
performed (oncoming lanes, road shoulders, etc.).
● Failure to perform appropriate driving operations and pay careful attention may lead
to an accident.
INFORMATION
■ Operating conditions of function
● This function is operable when all of the following conditions are met:
• The LTA is operating.
• The lane change assist function is enabled by a customize setting.
• The vehicle speed is between approximately 100 and 140 km/h (60 and 85 mph).
• The system recognizes the current road as a highway or expressway.
* :
If equipped
6-2. Using the safe driving support functions
413
6
Driving support system
To Next Page
Loading...
