WARNING
Allow the interior of the vehicle to warm up before using the liquid crystal information
display. At extremely low temperatures, the information display monitor may respond
slowly, and display changes may be delayed.
For example, there is a lag between the driver’s shifting and the new gear number
appearing on the display. This lag could cause the driver to downshift again, causing rapid
and excessive engine braking and possibly an accident resulting in death or injury.
NOTICE
To prevent the engine or components from being damaged, observe the following
precautions.
● Do not let the indicator needle of the tachometer enter the red zone, which indicates
the maximum engine speed.
● The engine may be overheating if "Engine Coolant Temp High Stop in a Safe Place
See Owner's Manual" is shown on the multiinformation display. In this case, imme-
diately stop the vehicle in a safe place, and check the engine after it has cooled
completely.
Related Links
Changing between the tachometer/hybrid system indicator/speedometer displays(P.
343)
Changing the distance driven display/resetting the distance driven(P. 344)
Customizable features(P. 791)
Rev indicator/Rev peak display
■ Rev indicator
When the engine speed reaches a set speed or the red zone, the tachometer will
be highlighted.
The indicators will be displayed in amber when the engine speed reaches a set speed, and
in red when the engine speed reaches the red zone.
The engine speed at which the Rev indicator is displayed can be changed on the
center display.
■ Rev peak
When the engine speed reaches or exceeds 4000 r/min, an afterimage of the
tachometer will be displayed at the highest engine speed for approximately 1
second.
5-1. Functions and displays of the meter
349
5
Vehicle status information and indicators
To Next Page
Loading...
