The wheel position registration procedure cannot be performed while the vehicle is
moving.
3 Select on the center display.
4 Select [Vehicle customise].
5 Select [Tyre pressure].
6 Select [Tyre rotation].
7 Select [Continue].
A message indicating that wheel position registration is being performed will be
displayed on the multi-information display. "---" will be displayed for the tire inflation
pressure of each tire and wheel position registration will begin.
8 Drive straight (with occasional left and right turns) at approximately 40 km/h
(25 mph) or more for approximately 10 to 30 minutes.
When wheel position registration is complete, a message indicating that registration
has been completed and the inflation pressure of each tire will be displayed on the
multi-information display.
Even if it is not possible to drive continuously at approximately 40 km/h (25 mph) or
more, registration can be completed by driving for a long time. However, if registration
does not complete after driving for 1 hour or more, park the vehicle in a safe place and
leave it with the power switch in ON for approximately 15 minutes or more, and then
perform the driving procedure again.
INFORMATION
■ When performing wheel position registration
● Normally, wheel position registration can be completed within approximately 30
minutes.
● Wheel position registration is performed while driving at a vehicle speed of
approximately 40 km/h (25 mph) or more.
■ Wheel position registration procedure
● If the power switch is turned off while registering the wheel position, the next time
the power switch is turned to ON, the wheel position registration will resume and
it will not be necessary to restart the procedure.
● While the position of each wheel is being determined and the inflation pressures
are not being displayed, if the inflation pressure of a tire drops, the tire pressure
warning light will come on.
8-5. Tire maintenance
627
8
Maintenance and care
To Next Page
Loading...
