● Only a change between both registered wheel set is possible, mixing between
these wheel sets is not supported.
● While registering ID codes, it may not be possible to change between wheel
sets normally. Cancel registration before changing between wheel sets.
1 Install the desired wheel set.
2 Select
on the center display.
3 Select [Vehicle customise].
4 Select [Tyre pressure].
5 Select the wheel set ([Set 1] or [Set 2]) displayed for the set selection setting.
6 Select the wheel set you wish to register, and then select [OK].
The tire pressure warning light will slowly blink 3 times, a message indicating that
change is occurring will be displayed, and the wheel set change will begin.
Wheel set change will begin and the tire pressure warning light will blink for 1 minute
and then illuminate. Also, while the change is being performed, "---" will be displayed
for the tire inflation pressure of each tire on the multi-information display.
After approximately 2 minutes, the wheel set
change will complete, the tire pressure warning
light will turn off, and a completion message will
be displayed on the multi-information display.
If changing does not complete after approxi-
mately 4 minutes, a message indicating that the
change could not be completed will be displayed.
Check which wheel set is installed and perform
the change procedure again from the beginning.
7 If the specified tire inflation pressure of the wheel set installed differs from that
of the previous set, it will be necessary to perform the tire inflation pressure
setting procedure of the tire pressure warning system.
If the specified tire inflation pressure is the same, it will not be necessary to perform the
tire inflation pressure setting procedure.
8 Register the position of each wheel.
Related Links
Registration of the position of each wheel after performing a tire rotation(P. 626)
8-5. Tire maintenance
634
To Next Page
Loading...
