4 Install the wheel bolt socket to the jack han-
dle.
5 Raise the vehicle until the tire is slightly raised
off the ground.
WARNING
Observe the following precautions when using the jack.
● Do not put any part of your body under the vehicle while it is supported by the
jack.
● Do not start the hybrid system or drive the vehicle while the vehicle is supported
by the jack.
● Do not raise the vehicle while someone is inside.
● When raising the vehicle, do not put an object on or under the jack.
● Do not raise the vehicle to a height greater than that required to replace the tire.
● Use a jack stand if it is necessary to get under the vehicle.
6 Remove the uppermost wheel bolt and install
the guide pin by hand.
Turn the guide pin clockwise to tighten it until it
stops.
WARNING
When removing or installing a tire, make sure to use the guide pin.
8-5. Tire maintenance
645
8
Maintenance and care
To Next Page
