Charging
mode
Outline
Mode 1
A charging method which does not use charging control to detect electri-
cal leakages between an external power source and the vehicle. Does not
apply to this vehicle.
Mode 2
A charging method which connects the vehicle to an external power source
through a AC charging cable equipped with a CCID (Charging Circuit
Interrupting Device).
Applies to charging through most household sockets.
Mode 3
A charging method which charges from a charger (such as at a public
charging station) equipped with charging control to detect electrical lea-
kages. Control to detect electrical leakages is implemented on the charger
side. Therefore, a CCID (Charging Circuit Interrupting Device) is not
equipped to the AC charging cable.
Not all chargers are equipped with AC charging cables. If there is no AC
charging cable available, use the Mode 3 AC charging cable equipped to
this vehicle.
■ Identification label
Identification labels are attached to the vehicle, AC charging cable and charger to inform
the user of which device they should use.
The meaning of the each identification label is as follows:
Identification
label
Supply type Standard Configura-
tion
Type of ac-
cessory
Voltage
range
AC EN 62196-2 TYPE 2
● Charging
port lid
● Charging
connec-
tor
≦ 480V
RMS
AC EN 62196-2 TYPE 2
● Charging
plug
● Charger
≦ 480V
RMS
1-3. Charging with the plug-in hybrid system
64
To Next Page
Loading...
