6 Extend the hose. Remove the air release cap
from the hose.
The air release cap may be used later. Therefore
keep it in a safe place.
7 Connect the hose to the valve of the flat tire.
Screw the end of hose clockwise as far as possi-
ble.
WARNING
Check the following.
● Make sure that the valve and hose are securely connected, with the tire installed
on the vehicle.
● If the hose is not properly connected to the valve, air leakage may occur or
sealant may be sprayed out.
● If the hose comes off the valve while inflating the tire, there is a risk that the hose
will move abruptly due to air pressure.
8 Make sure that the compressor switch is off.
9 Connect the power plug to the power outlet
socket.
9-4. If a tire is flat
713
9
When trouble arises
To Next Page
