If the AC charging cable is removed and reinserted while the charging indicator
is flashing, the charging schedule is canceled. Temporarily remove the AC
charging cable, and then reconnect it.
My Room Mode was operated
When My Room Mode is operated, the system will start charging, even if
the charging schedule is registered. To carry out charging using the charging
schedule, stop My Room Mode, and then reconnect the AC charging cable.
Traction battery heater operated
When the charging mode is set to [Departure time], traction battery heater may
operate before charging starts. Check the status of the charging indicator of the
charging port.
Charging ends earlier than time set in [Departure time]
Charging end time does not match estimated end time due to condition of
power source or outside temperature
If sudden changes in temperature or changes in the condition of the power
source occur while charging, charging may end earlier than the time estimated
by the system.
Charging is not complete, even though it is time set in [Departure time]
Charging end time does not match estimated end time due to condition of
power source or outside temperature
If sudden changes in temperature or changes in the condition of the power
source occur while charging, charging may end earlier than the time estimated
by the system.
Charging does not start, even though it is time set in[Start at set time]
AC charging cable was connected after set time
Connect the AC charging cable before the time set in [Start at set time].
9-8. If the plug-in hybrid system cannot be used normally
747
9
When trouble arises
To Next Page
Loading...
