NOTICE
● Do not apply a vibration to the charging connector while charging.
Charging may be stopped.
● Do not insert anything but the charging connector into the AC charging inlet.
● When inserting the plug into or removing the plug from the socket, make sure to hold
the body of the plug.
● Do not damage the AC charging inlet cap with a sharp object.
● Do not forcefully pull the AC charging cable that is caught or entangled.
If the cable is entangled, disentangle it before using.
● Do not disassemble, repair or modify the AC charging inlet.
When the onboard traction battery charger needs to be repaired, consult any author-
ized Lexus retailer or Lexus authorized repairer, or any reliable repairer.
■ When charging
Do not insert the plug into the AC charging inlet.
The AC charging inlet may be damaged.
■ Using private power generator
Do not use private power generators as a power source for charging.
Doing so may make charging unstable, the voltage may be insufficient, and the error
warning indicator on the CCID (Charging Circuit Interrupting Device) of the AC charg-
ing cable may flash.
■
Temperature which the AC charging cable can be used
● Charging may take a long time when performed in an environment where the ambient
temperature is -30°C or lower.
● Do not leave the vehicle or AC charging cable in an environment where the ambient
temperature is -40°C or lower.
■
Charging station
Due to the environment in which the power equipment is located, charging may be
unstable due to noise, the voltage may be insufficient, and the error warning indicator on
the CCID (Charging Circuit Interrupting Device) of the AC charging cable may flash.
■
Onboard traction battery charger cooling air intake vent
Cooling air intake vent for the onboard traction battery charger is installed under the rear
seats. Make sure to observe the following precautions regarding the cooling air intake
vent. Failure to observe these precautions may result in a charging system malfunction.
1-3. Charging with the plug-in hybrid system
84