4 300544660_002_C1 11/2016 - © Leybold
Service and Repair. Do not install substituted parts or perform any unauthorized modification to the
instrument. Return the instrument to a Leybold Calibration and Service Center for service to ensure
all of the safety features are maintained.
DANGER: Contaminated Parts
Contaminated parts can be detrimental to health and the environment. Before beginning to work,
find out whether any parts are contaminated. Adhere to the relevant regulations and take the
necessary precautions when handling contaminated parts.
DANGER: Overpressure in the vacuum system 2.5 bar < p < 5 bar
KF flange connections with elastomer seals (e.g. O-rings) cannot withstand pressure <2.5bar.
Process median can thus leak and possibly damage your health.
Safe Inlet Pressures. Never operate at pressures higher than the rated maximum pressure (refer
to maximum allowable pressure from Technical Data Chapter 2 section 2.1.
CE marking The transmitter complies with European standards for CE marking. Refer to
Declaration of Conformity in Chapter 10.
Caution: vacuum component
Dirt and damages impair the function of the vacuum component. When handling vacuum
components, take appropriate measures to ensure cleanliness and prevent damages.
Caution: Purge the instrument / dirt sensitive area
After installing the unit, or before removing it from a system, purge the unit completely with a clean,
dry gas to eliminate all traces of the previously used flow material.
This instrument must be purged under a ventilation hood and suitable personal protective
equipment must be worn for protection.
To Next Page
Loading...
Need help?
General
