Transport and Storage
35GA02411_002_C0 - 10/2016 - © Leybold
When installing the pump, the load must be spread equally across all 4 feet.
Unequal spreading of the load as well as high dynamic loads (by setting the
pump down too hard onto the disc-shaped feet) must be avoided.
2.1 Pumps with Castors
(available as accessory)
Some pump models are provided with a base frame equipped with four swiv-
elling castors with an integrated adjustable foot.
The pump is equipped with four swivelling castors for moving, but the pump
must only be transported with a forklift or crane as described in Section 2.
When moving the pump with a forklift or alike, ensure that the pump is
secured on the supplied palette or a suitable palette.
The pump must only be moved on a level floor! Moving to pump along slop-
ing paths or ramps is prohibited!
At the installation location unscrew with the adjustable feet so that the pump
is maintained horizontally, see fig. 2.2.
Fig. 2.2 Adjustable feet
The adjustable foot is screwed
out at the hexagon below the
red adjustment wheel. For this
a size 17 spanner is required.
Adjustable foot
Adjustment wheel
Spanner, size 17
To Next Page
Loading...
