Installation
18 GA01601_002_C1 - 03/2018 - © Leybold
3 Installation
Instructions for the operating personnel
Before any kind of assembly work the personnel must be informed in
advanced about potential hazards. Observe Safety Informations 0.1 to 05.
3.1 Placement
Explosion risk
The standard pump is not suited for installation in the explosion hazard
areas. Observe Safety Informations 0.5.
The TRIVAC D 2,5 E-LD pump can be set up on a flat, horizontal surface.
Rubber feet under the coupling housing ensure that the pump can not slip.
The location of the TRIVAC should be such that all controls are easily acces-
sible.
Risk of toppling
Max. tilt for the pump with possibly fitted standard accessories is 10° from
the vertical.
If you wish firmly install the pump in place, insert bolts through bore holes
(Ø5mm) in the rubber feet.
1
2
3
4
5
6
7
8
Fig. 7 Connections and controls
1 Intake port
2 Exhaust port
3 Oil fill
4 Oil level indicator
5 Oil drain
6 Name plate
7 Gas ballast valve
8 Mains connection
NOTICE
DANGER
CAUTION
To Next Page
Loading...
