45
206-4281
(Continued on next page)
Cloning Procedures (Cont.)
(Continued from previous page)
• If a Clone (.tlx) le (exported Master TV Setup) contains an FTG Channel Map, the physical RF
channels in the FTG Channel Map have been assigned logical channel numbers (see “Exporting
a Clone File” above). When you import the Clone le with the FTG Channel Map on the Target
TV(s), you will have the option to select either logical or physical channel tuning. Even if you
select physical channel tuning, the (list of) physical RF channels in the FTG Channel Map will
remain in logical order.
• If an FTG Conguration (.tlx) le (created in the FTG File Manager) contains an FTG Channel
Map, each logical channel number in the FTG Channel Map has been assigned a physical RF
channel or an Aux input (the latter designated by 130-0 through 137-0—see also Reference
section, “TV Aux Input Conguration”).
Note: When you import the FTG Conguration le on the Target TV(s), you will have the option to
select either logical or physical channel tuning. If you select physical channel tuning, the physical
RF channels and Aux inputs in the FTG Channel Map will remain in logical order.
• If the Target TV EBL is already in FTG Mode, you cannot use this procedure to make changes
to the FTG Channel Map and FTG Installer Menu settings. You must use a direct PC-to-TV
connection as described in Reference section, “FTG Mode via EBL (Local Conguration),” or an
FMA head end device to recongure the EBL.
• If the preceding condition applies, but you wish to switch the TV to FTG Mode via CPU, see Refer-
ence section, “Restoring Factory Defaults on the TV(s),” for further information before proceeding.
• If the Clone/Conguration (.tlx) le was edited/created in the FTG File Manager, it may contain
multiple zoned FTG Installer Menu proles for different TV models. Make sure it includes the
appropriate Installer Menu prole(s) for the Target TV(s) before performing the procedure below.
Caution: Do not unplug the TV power cord or remove the USB memory device while
importing is in progress, as doing so may cause the TV to malfunction or harm the
USB device, respectively.
Import Clone File Procedure
1. Turn ON the Target TV.
2. The next step depends on whether the LG Setup Wizard appears on the screen when you turn
ON the TV:
• If the wizard is displayed, you can complete the import procedure via the EZ-Manager Wizard,
as indicated above (see “Before You Begin”). However, to continue with this procedure and
access the “Import Clone File” option from the TV menus, exit the Setup Wizard. Then,
continue with step 3.
• If the wizard is not displayed, go directly to step 3.
3. If applicable (see also “Before You Begin” above), make sure to assign the appropriate Zone
designation in the Target TV at this time.
Note: In order for the proper location-specic TV Zone prole data to be applied,
the Zone designation must be assigned in the Target TV(s) BEFORE importing is
initiated.
4. Insert the USB memory device with the Clone/Conguration (.tlx) le into the USB port on the
Target TV.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
