75
206-4281
Troubleshooting
General Troubleshooting (Some Quick and Easy Tips for Resolving Problems)
Installation
Symptom Possible Cause(s) Possible Solution(s)
Cannot direct enter
channel number.
(TV in Pass-through Mode) Installer
Menu item 028 CH. OVERIDE is set
to 0, i.e., disabled (recommended
setting).
If the channel lineup is locked (recommended setting), only
channels that are active in the TV’s channel lineup can be
selected. Set 028 CH. OVERIDE to 1 to allow access for direct
keypad entry to all channels.
(TV in FTG Mode) The channel
entered is not included in the FTG
Channel Map.
Channel access is restricted to channels included in the FTG
Channel Map. If necessary, make changes to the FTG
Channel Map using the FTG File Manager or the FTG Device
Configuration Application, as appropriate.
No channels present
after Express Script.
Auto Tuning not run. Refer to Express Script procedure. Auto Tuning must be run in
order for the channel lineup to be populated. To reactivate the
Express Script, restore the TV to a factory default condition.
Picture Reception and Sound
Symptom Possible Cause(s) Possible Solution(s)
No picture. TV is turned OFF. • Turn TV ON.
• Power failure?
Antenna/cable not connected. Connect antenna/cable signal to TV.
Connections incorrect. Check connections on TV.
MPI not connected. If applicable, connect MPI cable to MPI device.
Encrypted program. Try another channel.
Wrong tuning band. Adjust Installer Menu settings.
Normal picture, poor or
no sound.
Broadcast problem. Try a different channel.
Audio muted. Press MUTE or use Volume Up key to increase sound level.
Pillow/TV speaker not configured
properly.
Check that Installer Menu items 020 FEATURE LEVEL and 027
HOSPITAL MODE are set as required. Also, if applicable, select
TV Speaker in the Audio Menu.
Erratic Operation
Symptom Possible Cause(s) Possible Solution(s)
Installer Menu setup. Wrong Installer Menu settings. Adjust Installer Menu settings as required.
Installer Remote (not supplied with TV)
Symptom Possible Cause(s) Possible Solution(s)
Remote doesn’t work. Remote not in TV Mode. Depending on the remote used, you may need to use a MODE
key to put the remote into TV Mode.
Not aimed at IR receiver. Point remote at IR receiver on TV.
Remote too far from IR receiver or
IR path is obstructed.
Move remote closer to IR receiver on TV, darken room, and/or
remove obstructions.
MPI not connected. If applicable, connect MPI cable to MPI device.
Weak batteries. Replace batteries.
Wrong battery polarity. Check that “+” and “-” match in battery compartment.
Too much light in room. Dim room light.
Remote IR codes do not match
setting(s) in TV.
Make sure the Installer Remote is compatible. Contact your LG
representative, as necessary. Then, check settings both in the TV
and on the remote. IR codes sent by the remote must match the
setting(s) in the TV.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
