22
ENG
ENGLISH
ASSEMBLING AND PREPARING / MAKING CONNECTIONS
Tidying cables
Image shown may differ from your TV.
1 Gather and bind the cables with the cable
holder.
2 Fix the Cable Management rmly to the TV.
Cable Holder
Cable management
CAUTION
y
Do not move the TV by holding the cable
holder, as the cable holder may break, and
injuries and damage to the TV may occur.
MAKING CONNECTIONS
This section on
MAKING CONNECTIONS
mainly uses diagrams for the 42UB82** models.
Connect various external devices to the TV
and switch input modes to select an external
device. For more information of external device’s
connection, refer to the manual provided with
each device.
Available external devices are: HD receivers,
DVD players, VCRs, audio systems, USB
storage devices, PC, gaming devices, and other
external devices.
NOTE
y
The external device connection may differ
from the model.
y
Connect external devices to the TV
regardless of the order of the TV port.
y
If you record a TV programme on a DVD
recorder or VCR, make sure to connect the
TV signal input cable to the TV through a
DVD recorder or VCR. For more information
of recording, refer to the manual provided
with the connected device.
y
Refer to the external equipment’s manual
for operating instructions.
y
If you connect a gaming device to the TV,
use the cable supplied with the gaming
device.
y
In PC mode, there may be noise associated
with the resolution, vertical pattern, contrast
or brightness. If noise is present, change
the PC output to another resolution, change
the refresh rate to another rate or adjust the
brightness and contrast on the PICTURE
menu until the picture is clear.
y
In PC mode, some resolution settings
may not work properly depending on the
graphics card.
y
If ULTRA HD content is played on your
PC, video or audio may become disrupted
intermittently depending on your PC’s
performance.
To Next Page
Loading...
Need help?
General
