LG CM24F - Page 27

THE INDOOR UNIT INSTALLATION
27
ENGLISH
Set screw of
paper model (4 pieces)
Paper model
for installation
Ceiling
board
150 mm
Ceiling board
Ceiling
Keep the length of the bolt
from the bracket to 40 mm
Open the ceiling board
along the outer edge of the
paper model
Air Conditioner body
Keep the length of 15~18 mm
between the air conditioner
bottom surface and the ceiling
surface
Adjust the
same height
4Way
Ceiling board
Set screw of
paper model (4 pieces)
Paper model
for installation
70 mm
Adjust the same height
Ceiling board
Ceiling
Keep the length of the bolt
from the bracket to 40 mm
Open the ceiling board
along the outer edge of the
paper model
Air conditioner body
Keep the length of 20~22 mm
between the air conditioner bottom
surface and the ceiling surface
1Way
Ceiling boardCeiling boardCeiling board
The following parts is option.
① Hanging Bolt - W 3/8 or M10
② Nut - W 3/8 or M10
③ Spring Washer - M10
④ Plate Washer - M10
Drill the piping hole on the wall slightly tilted
to the outdoor side using a Ø 70 hole-core
drill.
Wall
Indoor
Outdoor
5~7 mm
Tighten the nut and bolt to prevent unit
falling.
CAUTION
!
<Type : Round>
Tighten the screw as shown in the image so
the deco panel doesn’t move after the product
has been installed. (1 Spot)
Screws to tighten the deco panel are
contained in the indoor unit's accessory
package.
Flat washer for M10
(accessory)
Flat washer for M10
(accessory)
Hanging bolt
(W3/8 or M10)
Nut
(W3/8 or M10)
Nut
(W3/8 or M10)
Spring washer
(M10)
Ceiling board