LG CM24F User Manual

54
THE INDOOR UNIT INSTALLATION
ENGLISH
Heating Only Mode
Heating Only Mode switching
function setup
1 Supply the power to the unit with no
functions active.
2 Enter the Installer Code and set the code
to 47.
3 Press to select the code No.47 then,
check if buzzer beeps.
4 Cut the power to the unit.
5 Turn back on the power to the unit after 30
seconds.
Heating Only Mode switching
function disable setup
1 Supply the power to the unit with no
functions active.
2 Enter the Installer Code and set the code
to 48.
3 Press to select the code No.48 then,
check if buzzer beeps.
4 Cut the power to the unit.
5 Turn back on the power to the unit after 30
seconds.
* How to enter the installer mode
Press Reset Button and ‘A’ Button ( )
* How to set the code
Set the code you want by pressing TEMP
button (
_
) and press .
A
_
10 digit
1 digit
Press
SETUP
NOTE
- Once the function is set up, Cooling,
Dehumidification Auto Change over
cannot be used.
- Once the function is disable it will
return to its normal state.
- Code cannot be entered when it is in
operation mode. It must be OFF state
to enter code.
- Even if able to enter code in ON state,
it won’t function if the code is not
entered in OFF state.
- At Heating Only Mode, if the product
gets turned off while the wireless
remote control is set at other than
heating / blowing, the product will not
get turned back on. Turn off the
product after the wireless remote
control is set at heating / blowing and
then turn back on.

LG CM24F Specifications

General

Brand	LG
Model	CM24F
Category	Air Conditioner
Language	English