18
Lock (Parental Control) Settings
(Continues)
Set Password
1. Select [Set Password] option then press B.
2. Follow step 2 as shown “Rating” on page 17.
To change the password, select the [Change],
press ENTER and input the new password twice
after inputting the current password.
To delete the password, select [Delete] then input
the password.
If you forget your 4-digit code
If you forget your password, to clear the current
password, follow the procedure below.
1. Display Setup menu then select an any level 1
icon.
2. Use the Number buttons to enter the 6-digit
number “210499”.
3. Select [OK] then press ENTER. The 4-digit
password is cleared. Enter a new code.
Area Code
Enter the code of an area whose standards were used
to rate the DVD video disc, referring to the list (See
“Area Codes”, page 42.).
1. Select [Area Code] option then press B.
2. Follow step 2 as shown “Rating” on page 17.
3. Select the first character using the v / V
buttons.
4. Shift the cursor using B buttons and select the
second character using v / V buttons.
5. Press ENTER to confirm your area code selection.
Recording Settings
Record Mode Set
You can set the picture quality for recording;
XP (High Quality), SP (Standard Quality),
LP (Low Quality), EP (Extend Quality),
MLP (Maximum Long Play).
Auto Chapter
When recording in Video mode, chapter markers are
put at specified intervals. You can change this interval
to 5 minutes or 10 minutes. If you do not want chapter
markers on the disk being recorded, switch off
automatic chapter marking altogether with the [None]
setting.
To Next Page
Loading...
Need help?
General
