Getting Started with Your Phone
12
Removing the Battery
1. Turn the phone off.
2. Use the fingertip cutout at the
bottom of the phone to pull the
back cover off.
3. Use the fingertip opening
near the bottom of the battery
compartment to lift the battery
out.
Charging with USB
You can use your computer to
charge your phone. To be able to
charge with the USB cable, you
may need to have the necessary
USB Driver installed on your PC
first. Connect one end of the USB
cable to the Accessory/Charger
Port on your phone and the other
end to the USB port on your PC.
NOTE Low-power USB ports are not
supported, such as the USB ports on
your keyboard or bus-powered USB hub.
Battery Temperature Protection
If the battery gets overheated, the
phone will automatically turn off.
When you turn the phone back on,
a message pops up alerting you
that the phone was powered off for
your safety.
Battery Charge Level
You can find the battery charge
level
at the top right corner of
the LCD screen. When the charge
level becomes low, the battery
sensor sounds a warning tone,
blinks the battery icon, and/or
displays a warning message. As the
charge level approaches empty, the
phone automatically switches off
without saving.
Signal Strength
Call quality depends on the signal
strength in your area. You can tell
how much signal strength you have
by the number of bars next to the
signal strength icon
: the more
bars, the stronger the signal. If
you’re having problems with signal
quality, move to an open area or,
when inside a building, try moving
near a window.
Powering your phone on/off
Press and hold the PWR/
END Key until the screen
lights up.
Press and hold the PWR/
END Key until the display
turns off.
To Next Page
Loading...
Need help?
General
