63
PROGRAMMING MODE - TEST MODE
NOTE
• Never load laundry while using TUB CLEAN. The laundry may be damaged or become contaminated. Make sure to clean
the washer tub when it is empty.
• Leave the door open after finishing the laundry to keep the tub clean.
• TUB CLEAN should be repeated monthly.
• Safely and conveniently secure the door slightly ajar with a magnetic door plunger. This will promote air circulation and
allow the interior of the machine to dry.
Entering set up mode.
You will see LqC1
Button Display
Press the
Warm
or the
Cold
button until
appears in the display.
Press the
Start
button.
Press the
Warm
button until
appears in the display.
Press the
Start
button, then tub clean reset is done.
is displayed.
1. Continue to set up the next price.
2. Stop the change of setup value and go back to ready mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• OPL type – Push the Hot button twice.
7. Tub clean -
To clean up the tub, please run the TUB CLEAN cycle.
To Next Page
Loading...
