LG GCWP1069CS - Error Mode

70
ERROR MODE
ERROR MODE
Meaning of Error Codes that LED displays during occurrence of problem.
Problem Possible Cause Solution
•Watersupplyisnotadequateinarea.
•Watersupplytapsarenotcompletelyopen.
•
Waterinlethoseisbent.
•Thefilteroftheinlethoseclogged.
Checkanothertapinthehouse.
Fullyopentap.
Straightenhose.
Check
thefilteroftheinlethose.
•Drainhoseisbent
orclogged.
•Thedrainfilterisclogged.
Cleanandstraightenthedrainhose.
Cleanthedrainfilter.
•Loadistoosmall.
•Loadisoutofbalance.
•Theappliancehasanimbalancedetectionand
correctionsystem.Ifindividualheavyarticles
areloaded(bathmat,bathrobe,etc.)andthe
imbalanceistoogreat,afterseveralattemptsto
restartthespincyclethemachinewillstopand
theerrorcodewillbedisplayed.
Add1~2similaritemstohelp
balancetheload.
Rearrangeloadtoallowproperspinning.
•Isthedooropenedornotcompletelyclosed? Closethedoorcompletely.
✽
Ifitwillnotopen,callforservice.
•
Doorlockisbroken. Checkthedoorswitch.
•Thewateroverfillsduetoafaultywatervalve. Closethewatertap.
Unplug
thepowerplug.
Callforservice.
•Thewaterlevelsensormalfunction.
•Overloadinmotor. Restartthecycleafter30minutes.
If
isnotreleased,callforservice.
•Disconnectionofcardreadercable. Checkthecardreaderwire.
•Toomuchdetergentisused. Thisisnotanerror.Itindicatesasudsremovalroutine.
Itwillclearandrestartthecyclewhenthesudsaregone.
Unplug
thepowerplugandcallforservice.