Safety Precautions
4
Hydro Kit
• For antifreeze, always contact the dealer or an authorized service
center.
- Almost the antifreeze is a toxic product.
• The refrigerant of this product is R410A.
- The installation tool such as manifold gauge should be complied
with R410A.
• For installation, always contact the dealer or an Authorized Service
Center.
- There is risk of fire, electric shock, explosion, or injury.
• Do not install the unit on a defective installation stand.
- It may cause injury, accident, or damage to the unit.
• Be sure the installation area does not deteriorate with age.
- If the base collapses, the unit could fall with it, causing property
damage, unit failure, and personal injury.
• Do not install the unit outdoor.
- It may cause damage to the unit.
• Use a vacuum pump or inert (nitrogen) gas when doing leakage
test or purging air. Do not compress air or oxygen and do not use
flammable gases.
- There is the risk of death, injury, fire or explosion.
• Means for disconnection must be incorporated in the fixed wiring in
accordance with the wiring rules.
• This equipment shall be provided with a supply conductor
complying with the national regulation.
Operation
• Take care to ensure that power cable could not be pulled out or
damaged during operation.
- There is risk of fire or electric shock.
• Do not place anything on the power cable.
- There is risk of fire or electric shock.
• Do not plug or unplug the power supply plug during operation.
- There is risk of fire or electric shock.
• Do not touch (operate) the unit with wet hands.
- There is risk of fire or electric shock.
• Do not place a heater or other appliances near the power cable.
- There is risk of fire or electric shock.
To Next Page
Loading...
