3-2. Control the amount of water supplied to the icemaker.
Caution : • Unplug the power cord from the wall outlet and wait at least three minutes before removing the main PWB
cover. 310 Volts are present in the control panel.
1. Disconnect PWB cover from the upper part of the refrigerator.
2. Adjust the amount of water supplied by using the DIP
switches.
■ Water Supplying Time Control Option
1) The water supplying time is set at five seconds when the refrigerator is delivered.
2) The amount of water supplied depends on the setting time and water pressure (city water pressure).
3) If the ice cubes are too small, increase the water supplying time. This happens when too little water is supplied into the ice tray.
4) If the ice cubes stick togther, decrease the water supplying time. This happens when too much water is supplied into the ice tray.
Caution : When adjusting the amount of water supplied, adjust step by step. Otherwise the water may spill over.
3. When the adjustment of the control switch for the amount of water supplied is complete, check the level of water in the ice
HOW TO INSTALL THE REFRIGERATOR
- 15 -
* The quantity of water
supplied depends on DIP
switch setting conditions
and water pressure as it
is a direct tap water
connection type. (the
water supplied is
generally 80 cc to 120 cc)
* DIP switch is on the main
PWB.
GR-L267BV(T)R
(Refer to an appendix)
GR-L267BNRY
GR-L267BV(T)RA
(Refer to an appendix)
GR-L267BV(T,S)PA
No
DIP SWITCH SETTING
S1 S2
DIP SWITCH SETTING
S1 S2 S3
1
2
3
4
5
6
7
8
OFF OFF 6.5 SEC
ON OFF 5.5 SEC
OFF ON 7.5 SEC
ON ON 8.5 SEC
OFF OFF OFF 6.5 SEC
ON OFF OFF 5.5 SEC
OFF ON OFF 6 SEC
ON ON OFF 7 SEC
OFF OFF ON 7.5 SEC
ON OFF ON 8 SEC
OFF ON ON 9 SEC
ON ON ON 10 SEC
WATER
SUPPLY TIME
WATER
SUPPLY TIME
REMARKS
To Next Page
Loading...
