1-2. Oscillation circuit
The oscillation circuit generates a basic clock signal for synchronization and time calculation related to the transmission of
data and calculations made by the MICOM (IC1). The oscillator (OSC1) must always be replaced with an exact rated part,
because if this spec is changes, the time calculations of the MICOM will be affected and it might not work at all.
(1) GR-L267BV(T)R, BNRY (Refer to appendix)
(2) GR-L267BV(T)RA (Refer to appendix)
(3) GR-L267BV(T,S)PA (Refer to appendix)
EXPLANATION FOR MICOM CIRCUIT
- 34 -
To Next Page
Loading...
