1-3. Reset circuit
The RESET circuit allows various parts of the MICOM, such as RAM, defrosting, etc., to be restarted from the initial state
when power is interrupted or restored. A LOW signal applied to the reset terminal for 10 ms causes the MICOM to reset
itself. During normal operation, the voltage at the reset terminal is 5 Vdc. If the reset fails, the MICOM will not operate.
(1) GR-L267BV(T)R, BNRY (Refer to appendix)
(2) GR-L267BV(T)RA (Refer to appendix)
(3) GR-L267BV(T,S)PA (Refer to appendix)
EXPLANATION FOR MICOM CIRCUIT
- 35 -
To Next Page
Loading...
