5. WATER-VALVE DISASSEMBLY
METHOD
1) Turn off the power of the refrigerator (pull out the plug).
Open the F/R Door and disassemble the Lower Cover.
2) Lay a dry towel on the floor and get ready to pour water
from the water tank.
Then press the collet to separate the tube from the
connector and pour out the water until emptied.
(Refer to the label attached on Front L on how to
separate the tube.)
3) Lock the water being supplied. Then separate the Water
Connection connected to the Water Valve.
4). Separate the Cover Back M/C and Valve Screw.
5) Separate the housing and pull out the valve.
6. FAN AND FAN MOTOR DISASSEMBLY
METHOD
1) Using a short screw driver, loosen one SCREW in
DRAIN ASSEMBLY, PIPE-Z and one connected to the
COVER, MOTOR.
2) Pull and separate the FAN ASSEMBLY and MOTOR in
counter clockwise based on the MOTOR SHAFT.
The assembly is in the reverse order of the disassembly
and take special care for the following details.
1. Be careful not to bend the tube during assembly.
2. Press the WATER DISPENSER button until water pours
out and check for leakage in the CONNECTOR TUBE (It
differs by the water pressure but usually takes about 2
minutes until water pours out.)
HOW TO DISASSEMBLE AND ASSEMBLE
- 140 -
Cover Back M/C
Housing
*
Disassembly
1. Remove clip. (Retire la abrazadera.)
2. Pull out tube while presiona
(Extraiga el tubo mientras presiona
los anillos metalicos y desmontelo.)
*
Assembly
1. Insert tube until you can see only one line.
(Inserte el tubo hasta que solo puesa ver una linea.)
2. After inserting, pull out tube to check if it’s properly inserted.
(Tras insertarlo, extraiga el tubo para comprobar si ha sido insertado
correctamente.
3. Assemcie clip. (Monte la abrazadera.)
To Next Page
Loading...
