■ Install Water Filter (Applicable to some models only)
■ Before Installing Water Filter
1. Before installing the filter, take out the top shelf of the
refrigerator after tilting it to the direction and lifting it
to the direction and move it to the lower part.
2. Remove the lamp cover by pressing the protrusion
under the cover and pulling the cover to the front.
■ Installing water filter
1. Initial installation of water filter
Remove the filter substitute cap by turning it
counterclockwise by 90 degrees and pulling it down.
Note : Keep the cap safe to use it later when you do not
use the filter.
Remove the red cap from the filter and attach the
sticker. Insert the upper part of the filter after aligning
with the guideline marked on the control box, and fasten
it by turning it clockwise by 90 degrees.
Note : Check that the guideline and the fastening
indication line are aligned.
2. Replacement of water filter
While holding the lower part of the filter, turn it
counterclockwise by 90 degrees and pull it down.
Note : Check that the guideline and the loosening
indication line are aligned.
■ After installing water filter
Reassemble the lamp cover and the top shelf of the
refrigerator. To place the top shelf of the refrigerator, raise
the front part of the shelf a bit so that the hook of the shelf
is fits into the groove.
To purge the water filter system, let the water run for at
least 3 minutes.
NOTE : Open the refrigerator and check for water droplets
on the shelf under the filter.
HOW TO INSTALL THE REFRIGERATOR
To Next Page
Loading...
