1-1. Display Function
1-2. Display OFF Mode
1-3. Demonstration Mode (OFF Mode)
It places display in standby mode until any door is opened or any button is pressed.
Press FREEZER and ICE PLUS buttons simultaneously to turn ON all leds and 5 seconds after, these will turn OFF with the
recognition sound of “Ding~” (Be sure press both buttons for this to work).
Once the mode activates, all leds are always OFF except to dispensing icon (This depends on last selection dispensed). To
deactivate this mode, perform the same sequence used for activation.
1) Any Door must be opened to enter in this mode.
2) To activate this mode press and hold ICE PLUS and REFRIGERATOR button over 5 seconds.
3) The display will show the word “OFF” in Freezer and Refrigerator Temperature level.
4) In this mode all loads are turned off(Compressor, Heater, Fans, etc)
5) Lamps and Dispenser Functions will work normally (even in demonstration mode the refrigerator Lamp automatic off
function works normally)
6) To exit Demonstration mode open any Door then press and hold ICE PLUS and REFRIGERATOR button over 5
seconds (Display return to normal mode).
1) When the appliance is plugged in, it is set to 37°F for refrigerator and 0°F for freezer. You can adjust the Refrigerator and
the Freezer control temperature by pressing the ADJUST button.
2) When the power initially applied or restored after a power failure, it is set to the previously controlled temperature.
Display
OFF Mode
Demonstration
Mode
- 22 -
To Next Page
Loading...
Need help?
General
