To Next Page

To Previous Page

2. INSTALL WATER FILTER

Removing the water filter:

1. For first-time installation, remove filter substitute cap

(A) by turning it counterclockwise a quarter turn and

pulling it down. The substitute cap must be retained

for the future. If the filter is removed and not

replaced, it is necessary to reinstall the substitute

cap to prevent water leaks from the filter housing.

Installing the water filter

Remove red cap from the filter and insert the two

tabs on the filter tip into the two slots in the

refrigerator filter receptacle. You should feel the filter

entering completely. Turn the filter to the right a quarter

turn clockwise to lock it into place. The locked symbol

will be lined up with the indicator arrow.

After installing water filter

1. Replace the shelf to the initial position.

2. Turn on household water supply.

3. Dispense 2.5 gallons (9.46 L) of water to purge the

system, depressing and releasing the dispenser button

(30 seconds ON, 60 seconds OFF). Open the

refrigerator door and check the shelf area for leaks.

- 7 -

Before removing or installing water filter:

Take out the top shelf and move it to the lowest level.

2. IMPORTANT: Turn off household water supply.

• Filter Reset: When the Filter icon turns on, you

have to change the water filter. Press the Filter

button for 3 seconds to turn the icon .

2. For subsequent installation, remove old filter by

slowly turning it to the left a quarter turn and pulling it

down.

Filter

LG LSC27925ST Manual De Servicio

Other manuals for LG LSC27925ST