LG Pro:Centric 24LT572M - Page 18

18
206-4342
EZ-Manager Wizard (Cont.)
(Continued from previous page)
EZ-Manager Wizard
EZ-Manager Configuration Complete
Pro:Centric Application
Maintenance Files
GEM application downloaded
LT572M_Config.tlx
Installed Components
2
1
3
The TV will turn off in 3 second(s).
4
Reboot
Turn Off
Note: With the EZ-Manager Conguration Complete screen on display, you can also manually turn
off or reboot the TV. If desired, select Turn Off or Reboot, respectively, and then press OK on the
Installer Remote.
Manual Pro:Centric Conguration
1. With the Searching for Pro:Centric Server screen on display, use the Left/Right arrow keys on
the Installer Remote to select Manual Pro:Centric at the bottom right of the screen, and then
press OK.
In the Pro:Centric Manual Conguration screen (see example below), you will be able to
congure the appropriate Pro:Centric settings in the TV. Use the Up/Down arrow keys on the
Installer Remote to navigate between elds.
EZ-Manager Wizard
Pro:Centric Mode
Data Channel
Signal Strength
Signal Quality
1
<
Configuration Only
>
Back
Next
Exit
Pro:Centric Manual Configuration
0%
0%
No signal
4
3
2
1
2. In the Pro:Centric Mode eld, use the Left/Right arrow keys to select the appropriate Pro:Centric
Application Mode—GEM (Java) or Conguration Only.
Note: For remote management only, select Conguration Only. The TV will search for TV
E-Z Installation data downloads; however, Pro:Centric application data will not be downloaded,
i.e., Installer Menu item 098 PRO:CENTRIC will be set to 0.
3. In the Data Channel eld, either key in or use the Left/Right arrow keys to select the RF
channel number that will be used by the Pro:Centric server as its data channel. The Data
Channel value can be set from 1 to 135. *
(Continued on next page)
* PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.