EasyManua.ls Logo

LG TROMM F4999NTNH - Before Use and Setup; Pre-Operation Checks; Door Operation Guide

LG TROMM F4999NTNH
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Caution!
If the laundry is not fully pushed into the inside of the flexible gasket of the drum, the seal can be damaged resulting in a leak.
Overloaded laundry may cause damage to the washing machine and clothes.
Be careful that there may be an injury if hands are caught in between the door and product.
Note that the door glass can be broken by impact.
G
Before use
Check the following things first!
How to open the door
1
Is the water supply hose tightly connected
to the water tap and the tap turned on?
(54p)
2
Are the water supply hoses for hot water
and cold water connected correctly? (54p)
3
Is the power cord plugged in firmly? (58p)
4
Is the drain hose laid down into the
drainage?
5
Is the washer level? (56p)
Please note!
Drum washing machines use less water since they wash by
spinning and head dropping wet laundry.
It may seem like there is no water inside the drum during
washing, but that is normal as long as the laundry is wet enough.
A splashing sound during the washing cycle is due to the
dropping of the laundry while spinning and it is normal.
Laundry that absorbs a large amount of water for their small
size such as knitwear or foot mats need to be washed two or
more items at a time. If only one item is washed it may be out of
balance due to the one sided weight causing thereby the short
life service of the washer.
The amount of laundry is based on the test
laundry by the Korean Standard. Depending
on the type and volume of the laundry, the
actual amount of laundry may be different
from the specification.
The door cannot be opened during the operation or when the ‘Door Lock’ light
[
] is on. Do not attempt to open the door by force. Open the door after pausing
the operation by pressing the “Add Garments” or “START/PAUSE” button and the
“Door Lock” indicator is off.
To open the door
To close the door
Pull the
door
holding the
right rim of
the door.
Push the
center right
side of the
door to the
end.
Please note!
If there is
,
upon an Abnormal Alarm display, press the
‘START/PAUSE’ button after closing the door firmly.
The sound after pressing the ‘START/PAUSE’ button for starting is for
locking the door, and it is normal.
The sound after finishing the washing cycle or after pressing the ‘START/
PAUSE’ button for a pause is to unlock the door, and it is normal.
In case of the loss of power during operation, the door can be opened
after a set time (approximately 5 minutes). (Be careful of the heat when
the power shuts-off during the BOILING CARE course.)
If the loaded laundry is too much or the door is not
fully closed, the “Door Lock” indicator will not be on.

Related product manuals