Instructions for Installation
Check the transit bolts.
Confirm the 4 pcs. of transit bolts at the back of
the washer.
1
Check the drain hose.
Place the end of the drain hose lay down on the floor.
1
Install level.
Do not let the drain hose pass over the
high threshold.
2
Do not let the hose be
pressed.
Secure the drain hose so that it is not bent or
pressed.
Do not let the end of the drain hose sink
underwater.
3
Unscrew the bolts.
Unscrew the 4 pcs. of bolts using the spanner
supplied as an an accessory.
2
Remove the transit bolts.
(4 pieces)
Keep the removed transit bolts.
They will be used again to
protect the washer when
moving.
Close the holes with
the supplied 4 pcs
of caps.
3
If you run the machine without removing the transit bolts and level the machine, it may result in machine failure for the noise and vibration.
Removing Transit bolts
Installation of drain hose
Caution!
If the end of the drain hose is installed in a high place, it will not drain well.
Installation
and Check
To Next Page
Loading...
