LG V-NET ACS IO - While in use

- Failure to do so can cause fire and electric shock.
• Do not use a power cord that has been damaged, sabotaged or overly bent.
- Failure to do so can cause fire and electric shock.
• Do no connect the power cord to the control signal line socket.
- Doing so can cause fire and electric shock.
• Make sure the power cord is disconnected before performing any wiring work.
- Doing so can cause fire and electric shock.
• When connecting the connector be careful that the cable is not severed.
- Doing so can cause fire and electric shock.
While in use
• Do not alter or stretch the power cord.
- Doing so can cause fire and electric shock.
• Do not pour water in the product.
- Doing so can cause electric shock and malfunction.
• Do not use heating appliances near the power cord.
- Doing so can cause fire and electric shock.
• Do not place heavy items on top of the product.
- Doing so can cause malfunction.
• Do not place heavy items on top of the cord.
- Doing so can cause fire and electric shock.
• Children and seniors must supervised when the product is in use.
- Failure to do so may result in electric shock and cause the product to malfunction.
• In case water has entered the product, a request for repair must be made at the service center or
by an installation expert.
- Failure to do so can cause fire and electric shock.
• Do not knock the product.
- Doing so can cause the product to malfunction.
• When cleaning or inspecting be sure to turn off the power to the appliance.
• Do not touch the power source part with wet fingers.
- Failure to do so can cause fire and a deformation in the product.
• Confirm the operating temperature.
- Using the product in at a temperature that exceeds the operation temperature range can cause
severe damage. Confirm the prescribed range of service temperature enclosed in the manual. If
there is no prescribed temperature use within a range of between 0~40 °C.
• Do not place a liquid-filled container on top of the product.
- Doing so can cause fire and electric shock.
CAUTION
When installing
• Confirm the rated capacity of the power source.
- Failure to do so can cause fire and a deformation in the product.
• When selecting a transformer
- When selecting a transformer you must select a product with safety isolation that meets
IEC61558-2-6 NEC Class 2 regulations. Also, when selecting an appropriate transformer, each
installed module, accessory and volume of total energy consumption of the field devices must be
considered. The ACS IO Consumption Current: 24 V~, 500 mA
- This is device current only. External loads must be added when using common power supply.
While in use
• Do not use a powerful solvent as a detergent for cleaning, use a soft cloth instead.
- Failure to do so can cause fire and a deformation in the product.
!
ENGLISH
SAFETY PRECAUTIONS
4