55
1
Disassemble the lower cover assembly.
2
Take out the main PCB assembly from the
front of the washer.
3
Remove 3 clamps from the each hose.
4
Remove 3 screws from the base cabinet.
5
Disconnect the wire of pump.
6
Take out the drain pump assembly in the
direction displayed in the fig.
1
Loosen the nut.
2
Remove washing heater by pulling out.
When assembling the washing heater, insert
the heater to heater clip on the bottom of tub
and check the position of wire color.
DRAIN PUMP ASSEMBLY
HEATER
< Heater for Washing>
• Rating : 230V 2000W
• Resistant : 24.5~28.5Ω
CAUTION
To Next Page
Loading...
