How to use the adjusting plates
Use the adjusting plates to level the washer
when the adjustable legs cannot cover the gap.
Checking level
Open the lid, and check if the
washer is correctly leveled by
looking down from the top.
3
Set rear legs
Remove the level and tilt the washer
forward (pivot on front legs) about 4 to
6 inches and gently lower the rear
legs back onto the floor. This action
will set rear leg adjustments to
correspond to front settings
Installation area
Install the washer on flat and firm
surface.
12
Improper installation of the washer may cause noise and malfunctioning.
1. The ventilating openings in the base area must not be obstructed be
carpeting when the washing machine is installed on a carpeted floor.
2. Install the washing machine on a level and firm surface, any tilt should be
less than 1° .
Turn the adjustable legs to set the washer
horizontal(2EA).
To Next Page
Loading...
