37
4-6. TEST RUNNING WITHOUT WATER
•
To use the CHECK PROGRAM (QC TEST MODE), press WATER LEVEL, WATER TEMP. and POWER button ON
without depositing any laundry.
•
In QC TEST MODE all LEDs are on and press START(PAUSE) button to check over the following items.
NO
1
CHECK METHOD
Initial state
•
WATER LEVEL frequency is on
DISPLAY in the condition of no water
in TUB.
•
All LEDS ON.
64~70 DISPLAY.
•
Laundry amount test.
•
COLD water.
•
If Error of EEPROM is occured,
is on the display
•
HOT water.
•
Additives Valve.
•
Bleach water.
•
DRAIN MOTOR is 2 st start.
•
DRAIN PUMP is on.
•
ALL LEDS OFF.
•
RINSE water.
•
if Wash capacity is 10~12KG,
is on the display.
•
if Wash capacity is 10~12KG,
is on the display
•
If the LID is opened, is on the
DISPLAY. In that case, close the LID.
•
DRAIN MOTOR is 1 st start.
•
After detecting laundry amount the
number of pulse is on the DISPLAY.
•
AUTO OFF.
2 Press once
3 Press twice
4Press 3 times
5 Press 4 times
6 Press 5 times
7 Press 6 times
8 Press 7 times
9 Press 8 times
10 Press 9 times
11 Press 10 times
DISPLAY CHECK ITEM
To Next Page
Loading...
