9
2-3. CONNECT THE DRAIN HOSE
• Connect the drain hose to the
outlet of the drain pump located
at the rear of the washing
machine.
NOTE : • Never lay down the drain hose, as water will be discharged.
• Be sure the drain hose is properly routed so it will not kink or lift from the sink.
• The discharge height should be approximately 0.9 ~1.2 m from the floor.
• Connect the drain hose adjusting the length of it not to be dropped. If drain hose is dropped the
drainage could be poor because of blockage in the hose.
• Do not install the washer where it is directly exposed to sunlight, wind,
rain etc.
•Plug the power cord of this washer into a properly installed standard
electrical outlet that is switched & earthed.
• Attach the clip to the drain hose.
And then push it toward the body
of the washing machine as
indicated by the arrow.
• Check that the drain hose is
hung up over the edge of the
laundry tub.
• Do not use an extension hose.
To Next Page
Loading...
