WM2277 WASHER PAGE 17 of 84 TRAINING MANUAL
INSTALLATION (PEDESTAL KIT)
This procedure covers installing and leveling the 7½” and 13” pedestals for 27”
washers, dryers, and combos. If the products are stacked, the washer must be
below the dryer, and you’ll use only one pedestal.
1. Remove the pedestal,
installation hardware, and
instructions form the shipping
carton. Set the pedestal as close
to the installation position as
possible.
2. Level the pedestal on a flat, solid
floor before proceeding. Lock
down the rear adjusters but
leave the front ones free for now.
3. Note which holes are for the
washer and which are for the
dryer. If you are stacking the
appliances, the washer must
be on the bottom.
4. Remove the protective paper
from the adhesive surface of the
bracket. Be particularly careful,
because when the adhesive
makes contact, there is no
adjustment possible.
To Next Page
Loading...
