WM2277 WASHER PAGE 50 of 84 TRAINING MANUAL
DISASSEMBLY/REPAIR (Dispenser)
1. Remove the top plate.
(See page 46.)
2. Remove the dispenser drawer.
3. Remove two screws to release
the dispenser.
4. Loosen the clamp on the large
hose that runs from the
dispenser to the drum.
Have an old towel handy to stuff
under the dispenser to soak up
any spillage.
5. Disconnect the connector from
the solenoid. Make a note of the
color codes and connections.
#1 Blue; yellow/black (bleach)
#2 White; white/black (main)
#3 Blue; white/black (pre-wash)
#4 Red; blue/black wires (hot)
They should measure 120 V
AC
± 10% or
950~ 975 Ω with the harness
disconnected.
6. Remove two screws from the
back of the cabinet
DISASSEMBLY/REPAIR (Noise Filter)
1. Remove the connectors from the
noise filter.
2. Remove the screw from the top
bracket.
3. Replace the filter as an
assembly. There are no user-
serviceable parts in it.
The white connector is input; the
pink is output. Both are 110 V
AC
.
To Next Page
Loading...
