COMBO
WM3677 COMBO Page 11 of 68 TRAINING MANUAL
(Back of COMBO)
The air vent must be left open and clear at all times. If the combo is installed in a
closet or closed laundry alcove, there must be sufficient clearance and ventilation.
The closet should have a full louvered door with at least 800 square inches of
open area for ventilation.
The COMBO requires a space of at least 1 inch between the wall and the
machine on each side and at least 4 inches between the back of the washer and
the wall. Additional space may be needed for servicing.
ACCESSORIES
The COMBO comes with the two input hoses. The blue stripe is for cold water
and the red stripe is for hot water. While the hoses are mechanically identical, it
is critical to the performance of the COMBO to have the hot and cold hoses
connected correctly.
The wrench is used to remove (and replace) the shipping bolts and to adjust the
leveling feet. Be sure to leave it and encourage the customer to retain the wrench,
the four shipping bolts, and the manual in a safe place in the event the washer
requires service or the customer moves.
The shipping bolts MUST BE REMOVED before operating the COMBO.
To Next Page
Loading...
Need help?
General
