COMBO
WM3677 COMBO Page 45 of 68 TRAINING MANUAL
TUB REMOVAL AND REPAIR
Removing the tub requires that you first remove the control panel and the front
panel. The front panel can be removed without removing the door. (See previous
pages for this procedure.) When the front has been removed, it is easy to remove
the tub. Remove the counterweights first to make this job easier. Regardless,
most of this procedure will require a helper.
1. Remove the bolts retaining the
weights. (4 per weight)
2. Set the weights aside where
they will not fall and break or
cause injury.
The weights balance the motor
when removing the tub. If you
remove them, the tub will be
back-heavy.
3. Disconnect the wire lead to the
thermistor.
4. Disconnect the wires on the
heating element.
5. Remove the center bolt
securing the ground and the
element.
6. Pull the element out carefully.
To Next Page
Loading...
