COMBO
WM3677 COMBO Page 39 of 68 TRAINING MANUAL
FRONT CABINET COVER
1. Remove the four screws from
the top edge of the front cabinet
cover.
2. Remove the screw behind the
filter cover.
3. Use a putty knife or screwdriver
on both sides (one at a time)
of the filter cover and pull it out.
4. Remove the screw that was
hidden by the filter cover.
5. Open the COMBO door.
6. Use the special gasket pliers
(part # 383EER4001A) to
remove the gasket clamp/spring
assembly.
(See photo, page 66.)
To Next Page
Loading...
