Why is the battery run time less than specified on my Liebert UPS?
If the battery run time of your Liebert UPS is less than expected, ensure the battery breaker is in the ON position. If it is off, switch it on. Also, the batteries may not be fully charged. You may try charging the batteries and testing the backup time. If the problem continues, it might indicate defective batteries or a faulty charging device.
What to do if FAULT LED illuminates and alarm sounds constantly on Liebert UPS?
If the FAULT LED is lit and the alarm is constantly sounding on your Liebert UPS, this indicates a UPS error or overheating. To address overheating, try to decrease the ambient temperature around the UPS.
Why Liebert UPS on LED does not light up, and alarm beeps sound at intervals?
If the UPS on LED does not light up and alarm beeps sound at intervals on your Liebert UPS, it could be due to no utility mains voltage being present. In this case, have the utility mains inspected by a qualified technician.
What to do if Liebert UPS shows OVERLOAD message?
If the Liebert UPS displays an OVERLOAD message, it means there's too much load on the UPS output. To resolve this, reduce the amount of equipment plugged into the UPS to a level within its specified capacity.
How to fix Liebert UPS with no display and no alarm?
If your Liebert UPS has no display and no alarm and is switched off, first check if the utility mains are switched off. If they are, switch them on. If the mains are on but there's no voltage, have them inspected by a qualified technician. Also, inspect the input fuse or circuit breaker. If a fuse is blown, replace it with the same type. If the circuit breaker is tripped, switch it back on. If the problem continues, further assistance is needed.
What to do if Liebert UPS on LED doesn't illuminate when utility mains voltage is present?
If the UPS on LED of your Liebert UPS does not light up when utility mains voltage is present, and the acoustic alarm is active at intervals, the input fuse may be defective, or the input circuit breaker may have tripped. Replace the fuse with one of the same type or switch the circuit breaker back on.
How to troubleshoot no communication between Liebert UPS and PC?
If there is no communication between the Liebert UPS and your PC, make sure you are using the correct serial connection cable and not a standard modem/null modem cable. Check if another software/service is accessing the interface on the PC and try selecting a different serial interface. Also, try laying the cable differently or reinstalling the cabling to address potential interference.
To Next Page
General