51
Maintenance and Tips
Troubleshooting
Problem: The Core Balance values seem incorrect, such as when you stand
in a balanced way on the pedals, without pedaling, produces diering
values.
Solution: Recalibrate the Core Balance sensors in the pedals.
Procedure:
1. Enter Enginering Mode by pressing and holding the START and LEVEL +
(up) for three seconds. The display shows ENGINEERING MODE.
2. Press ENTER. The display shows LOADCELL SETUP.
3. Press START. Stand on your left foot only. Use the handlebars for balance
only. Stand this way for four seconds.
4. Press START again. Stand on your right foot only. Use the handlebars for
balance only. Stand this way for four seconds.
5. Press START a third time. Stand normally.
6. Press ENTER repeatedly until you exit Engineering Mode.
The right and left Core Balance sensors will now show the same value when
the same pressure is applied.
To Next Page
Loading...
