Lifetime 90192 - Page 23

23
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
Screw the "ASE#AP!*.onto the "ASE!*- as shown.
SEC
2.1
Slide the vXv!XLE!*$ through one of the 7HEELS!-5 and into
the "ASE!*-as shown. Then have one adult position the Bottom Pole (ALE)
within the Base as shown with the lip at the bottom of the pole facing
outward. Insert the 1/2” x 21 3/4” Axle through the Bottom Pole and into
the other side of the Base and through the other Wheel.
SEC
2.2
!*-
!*.
!*-
!*$
AMU
AMU
Note: Make sure the Rubber Gasket is inside the Base Cap.
!
Note: It may be necessary to use a Rubber
Mallet to tap the Axle into place.
!
!*.
2UBBER'ASKET
./(!2$7!2%2%15)2%$&/24()30!'%
ALE