TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
SEC
5.12
Hook one of the ends of a #OUNTERBALANCE3PRING!*9 into the #3 hole
on the ,EFT"ACKBOARD"RACKET!** as shown.
SEC
5.13
Using the closed end of a Wrench, stretch the 3PRINGS!*9 up and over
the 3/8” x 7” Hex Bolt (AAZ) one at a time as shown.
Note: Make sure all hardware has been securely tightened before moving to the next section.
!
7RENCH
./(!2$7!2%2%15)2%$&/24()30!'%
Note: Repeat this step to hook the end of the other Spring
into the #3 hole in the Right Backboard Bracket (AJK).
!
!*9
!**
3
!*9
AAZ
To Next Page
Loading...
