-24-
LIFEWARMER
™
GLOSSARY OF TERMS
Quantum Blood & Fluid Warming System COMPONENTS LIST
APPENDIX
TERM DESCRIPTION
Controller Command center the System. Contains the microprocessor that assesses and regulates temperature.
Controller Jacket
Jacket permits the mating (connection) of the TIS or TTS-B tubing circuit connector to the connector
slot on the Controller. Protects the Controller and should be replaced after approximately 10 uses or 6
months. The Jacket must remain in place for device operation.
Set point temperature The manufacturer pre-set temperature of the System = 38ºC +/- 2ºC
mL/min Millileters per minute
IP
Ingress Protection. Rating system for for electronic equipment and/
or housings to against solids (1st digit) and liquids (2nd digit).
IP 22
Solids: Protected from solids >12.5mm
Liquids: Protected from dripping water.
IP 53
Solids: Protected from limited dust ingress.
Liquids: Protected from water spray less than 60 degrees from vertical.
IP 64
Solids: Protected from total dust ingress
Liquids: Protected from water spray from any direction
IP 67
Solids: Protected from total dust ingress.
Liquids: Protected from immersion between 15 centimeters and 1 meter in depth.
PART NUMBER DESCRIPTION
35-0001 Quantum Battery
35-0002 Quantum Charger
35-0003 Quantum Controller
35-0004 Quantum Thermal Infusion Set (TIS)
35-0005 Quantum Thermal Transfusion Set (TTS-B)
35-0006 Quantum System (Kit): 1 x Controller, 1 x Battery, 1 x Charger, 2 x TTS-B
Blood & Fluid Warming System
To Next Page
Loading...