Getting Started
248083317-1 Rev 4 3-7
13. Squeeze the latch tab to allow it to enter the slot in the housing as
shown in Figure 3-8 and pull the cable through the connector
housing, bringing the RJ45 into the housing.
Figure 3-8 Close-up of RJ45 Latch
14. Push the RJ45 connector fully into the housing and insert the Lock
Clip, round edge out as illustrated in Figure 3-9, until it is flush.
Figure 3-9 Lock Clip Installation
15. Hand tighten the Clamping Nut until snug. See Figure 3-10.
Figure 3-10 Tighten Cable Clamp Nut
To Next Page
Loading...
