12
1. Overview 2. Initial Set-up 3. DaiIy Operation
4. Additional
Information
5. Maintenance &
Troubleshooting
6. Safety &
Specifications
TEACHER BELT-PACK CONTROLS AND
FUNCTIONS
1. POWER SWITCH: powers
the belt-pack on/off. Press
up to power on. The power
automatically shuts off for
charging.
2. TEACHER 1 STATUS
INDICATOR: this multi-purpose
LED indicates power, low battery
and ready for operation for the
belt-pack registered as Teacher
#1.
UÊ Initial power on: blinking
blue
UÊ “READY” for operation:
solid blue
UÊ Low battery: red
3. TEACHER 2 STATUS
INDICATOR: this multi-purpose
LED follows the same function
as the Teacher 1 indicator for the
belt-pack registered as Teacher
#2.
4. REGISTER: press this button to
register a new belt-pack. The
belt-pack comes pre-registered
with the base station. This only
needs to be activated if the belt-
pack is replaced for service or an
additional one is added.
5. REGISTRATION IN PROGRESS
(NOT SHOWN): the Teacher
1 and 2 status indicator LEDs
will blink alternately to indicate
the belt-pack is in process of
registering.
6. CHARGING INDICATOR: this
LED turns RED when charging,
green to indicate charging
complete.
7. HEADSET CONNECTION: the
teacher headset connects to this
2.5mm jack.
8. AUDIO INPUT: connect an
external device like an iPod or
computer to send multimedia
audio to any or all group
speakers.
9. BELT-CLIP: use this clip to
secure the belt-pack to a belt or
pocket. Alternatively, the belt-
pack can be placed inside the
pocket.
10. BATTERY COMPARTMENT:
remove screw and open to
replace rechargeable battery
pack.
2
3
6
7
1
8
9
4
10
To Next Page
Loading...
